Chord CPA 3000 Pre Amplifier
Chord CPA 3000 Pre Amplifier
The CPA 3000 shares many of the features found in the entry-level CPA 2500, but also draws on technologies found in our flagship Reference range preamps. Compared to its CPA 2500 sibling, the CPA 3000 introduces four balanced inputs with three unbalanced RCA inputs and, on the output side, there are one pair of balanced XLR outputs and a single pair of unbalanced RCA outputs.
The CPA 3000 also retains the record output facility shared with the CPA 2500: a single tape loop is available for playback and also to record from any of the connected sources. The CPA 3000 also benefits from features such as our proprietary high-frequency switch-mode power supply and ultra-low-noise circuitry, to give the very best noise floor performance.
Chord CPA 3000 Pre Amplifier
| Manufacturer Link | Chord SPM 6000 MKII Mono Power Amplifier 750W |
|---|---|
| Manufacturer | Chord Electronics |
| Free warranty | 5 years |
| Delivery Charge | Free |
| Delivery Time | 1 - 5 Working Days |
| Card Surcharge | No |
Chord CPA 3000 Pre Amplifier
Frequency Range:
2.5Hz – 200kHz +/- 3dB
Total Harmonic Distortion:
0.002% 20Hz – 20kHz
Intermodulation Distortion:
-100dB on all inputs
Signal to Noise Ratio:
-93dB on all inputs
Channel Separation:
10Hz @ 90dB, 1kHz @ 90dB, 10kHz @ 90dB, 20kHz @ 85dB
Channel Balance:
0.01dB
Input Max Voltage:
10v RMS Balanced – 5v RMS Unbalanced
Output Max Voltage:
15v RMS Balanced – 5v RMS Unbalanced
Output Offset:
0mV (Both Channels)
Potentiometer Performance:
0dB 0.5dB, -20dB 0.2dB, -60dB 0.24dB (13seconds Full Travel)
Nominal Gain:
Fixed at x 1.1
Input Impedance:
94 kΩ Balanced – 75 kΩ Unbalanced
Output Impedance:
100Ω (Short Circuit Protected)
Operating Voltage:
85v – 270v AC (50Hz – 60Hz) Auto Switching
Dimensions Without Integra Legs:
420mm (w) x 355mm (d) x 88mm (h)
Dimensions With Included Integra Legs:
480mm (w) x 355mm (d) x 128mm (h)
Weight:
10kG
Chord CPA 3000 Pre Amplifier