Pro-Ject Amp Box DS Mono Power Amplifier

£325.00
In stock
See more Pro-Ject products.

The sound quality of Amp Box DS Mono is aimed to be as close as possible to Class A tube amplifiers with their liquid and lifelike presentation. This stylish amp is compact-sized and therefore lends itself to easy placement and can be switched on & off remotely via a trigger signal. A 45cm power-on cable is supplied for this purpose. A ultra high-efficiency Bi-Phase PWM (Pulse Wave Modulation) circuit with SMD parts gives outstanding audio performance and stays cool on the outside. For Bi- or Tri-amplification use, the remote power-on signal can be relayed to further units.
OR
More Information
Manufacturer Link Pro-Ject Amp Box DS Mono Power Amplifier
Manufacturer Pro-Ject
Free warranty 2 years
Delivery Charge Free
Delivery Time 1 - 5 Working Days
Card Surcharge No
See more Pro-Ject products.

Pro-Ject Amp Box DS Mono Power Amplifier

Key Features:

Improved PWM-Circuitry (Pulse Wave Modulation)
Improved signal spectrum and lower distortion
Discrete design for ultra-dynamic playback and highest resolution
SMD for short signal paths
Class D amplification means low heat emission
Ultra high-efficiency: approx. 92% of power consumption goes to “power out”
Gold-plated, over-sized binding posts
Trigger-switching with Loop-out
RCA Loop-out, for Bi-Amping, etc
Outboard power supply included

Technical Data:
Power Output: 1 x 110W/190W @ 8 Ohms/4 Ohms
Frequency Response: 10Hz - 50kHz (+ 0dB, - 3dB)
Signal To Noise: Ratio >-100dB (IEC -A)
THD: < 0,1% @ 90W
Gain: 26dB
Pre-amp Input: 1x RCA With Loop-Out
Input Sensitivity: 1,5V
Input Impedance: 100kohm
Speaker Port: 4mm Ø Banana, Spade Or Bare Wires
Trigger 12V DC: In&Out, 2-Pole Jack Ø 2,5mm
External Power Supply: 48V/2,5A DC;100 - 240V, 50/60Hz
Standby Power: Consumption < 1 watt
Dimensions W x H x D: 103 x 72 x 144 (163mm With Sockets)
Weight: 1290g Without Power Supply

Pro-Ject Amp Box DS Mono Power Amplifier

Call us about this product